LogTag UTRIX-16 - User Manual

Other manuals for LogTag UTRIX-16

Need help?

Do you have a question about the LogTag UTRIX-16 and is the answer not in the manual?

Mounting SMD components, crystal, and USB connector onto the PCB.

Programming firmware, serial numbers, and performing PCBA functional tests.

Mounting PCB into the case and applying conformal coating for protection.

Installing battery, applying sealant to crystal/case, and inserting light pipes.

Pressing case halves together and securing them with screws.

Performing USB LogTag tests, button checks, and temperature cycle tests.

Applying protection tape over LEDs and switch holes.

Setting up product for shipping, including labelling and serialisation.

Packing the finished LogTag units into protective covers and shipping boxes.

Temperature Specifications

temperature sensor measurement range	-25°C to +70°C (-13°F to +158°F)
operating temperature range	-25°C to +70°C (-13°F to +158°F)
storage temperature range	0°C to +40°C (32°F to +104°F)

Humidity and Environmental Specifications

ambient humidity range during transport and use	0 to 95%RH
vibration compliance	EN12830:1999
shock compliance	5 drops from 1m onto smooth concrete floor

Power and Battery

power source	CR2032 3V Li-MnO2 battery
battery life	2 years of operation with normal use
shelf life before configuration	up to two years

Dimensions and Weight

Temperature Specifications

temperature sensor measurement range	-25°C to +70°C (-13°F to +158°F)
operating temperature range	-25°C to +70°C (-13°F to +158°F)
storage temperature range	0°C to +40°C (32°F to +104°F)

Humidity and Environmental Specifications