LogTag TRIX-8 V2 - Page 7

LogTag TRIX-8 V2 Work Instruction Manual Revision 10.17 Page 7/44
MANUFACTURING PHASE 2: Product assembly & test
Solder on battery (2.1)
COMPUTER TEST
LogTag Test & Setup (2.6)
Place Failed product in
marked container with this
test number for servicing.
FAIL
PASS
Add sealant to sensor area (2.3)
Press case halves together (2.4)
PASS
INSPECTION
Case thickness (2.5)
Squeeze case together using
toggle clamp to insure case
thickness to specification.
FAIL
Apply clear tape over switch hole in case (2.10)
COMPUTER TEST
LogTag Check & Final Test (2.12)
Place Failed product in
marked container with this
test number for servicing.
FAIL
PASS
Screw in case screws (2.8)
Press Light-pipes into LED holes in case (2.9)
MANUFACTURE PHASE 3
CUSTOMISATION
Apply foam dot to battery (2.2)
Temperature cycle stress test (2.11)
Place Failed product in
marked container with this
test number for servicing.
FAIL
PASS
ACTION/INSPECTION
Push Start Button Start (2.7)
observe LEDs blink to indicate start
PASS
Stack for 10mins before processing in next test (2.6)
Stack for 10mins before processing in next test (2.12)