Instructions for use Lojer Modux nursing bed / Version 2.5
Copyright © Lojer Oy, 2022 21
6.7 Adjusting the back section
The tilt angle of the nursing bed can be adjusted between 0–71°.
Make sure your hands are not between the backrest and the upper
frame parts when adjusting the backrest (danger of crushing).
There is a danger of crushing when the lift support is in place and the
back section is adjusted.
Raise or lower the back section by pushing the appropriate button on the hand
control unit.
1 Raising the back section
2 Lowering the back section
Image 29. Raising and lowering the back section
6.8 Emergency lowering of the back section
During power failures and in case of device failure, you can manually lower
the back section of the hospital bed when the bed is in the operating position.
Make sure your hands are not between the backrest and the upper
frame parts when using CPR mechanism. Use CPR function only in
emergencies and be particularly careful when doing so (danger of
crushing).
1. Support the back section with one hand.
2. Remove the emergency lowering pin at the attachment of the upper end
of the back section motor.
3. Pull off the emergency lowering peg.
4. Gently lower the back section.
To Next Page
Loading...
