Instructions for use Lojer Modux nursing bed / Version 2.5
Copyright © Lojer Oy, 2022 36
Do not subject the bed to excessive moisture which may result in
water gathering in places and damaging the bed.
Do not use solvents, petrol, or acids for general cleaning of the bed.
See above for material-specific instructions.
Dry all surfaces thoroughly after cleaning and disinfection.
Disinfection wears down the surfaces. After disinfecting the bed, clean
the surfaces using a clean and damp wipe. Dilute disinfectants
according to the manufacturer’s instructions.
8.2 Hygienic mattresses
Remove all secretions and impurities from the mattress as soon as possible or
at the latest when the user changes. It is recommended to air the mattress
periodically to remove possible moisture. The mattress’s interior should not be
washed, as this may damage the structure and properties of the mattress.
Wash the hygienic cover of the mattress thoroughly with warm water (50 C)
and a neutral (pH7) detergent. Finally, rinse with clean water, wipe dry and
leave to dry at room temperature. Check that the mattress surface is dry
before the next use. Use a small brush to clean corners and to remove difficult
stains. If necessary, dilute the cleaning agent according to the manufacturer’s
instructions.
The disinfection of the hygienic cover of the mattress should be carried out
with a detergent containing alcohol. If the disinfectant used is too
strong/undiluted, this may weaken the surface of the hygienic cover and
shorten the lifetime of the mattress. The use of chlorinated detergents is not
recommended.
Alcohol can cause drying/weakening in the surface of the hygienic
cover, and therefore care should be taken when disinfecting the cover
with a detergent containing alcohol.
8.3 Wood surfaces and other materials
Laminate parts, wooden surfaces and other similar materials should be
washed with water and a mild detergent. For the removal and disinfection of
difficult stains, a detergent containing alcohol can be used. After washing,
rinse with clean water and wipe the surface dry with a towel or cloth. Do not
use polishing agents.
To Next Page
Loading...
