3.2.4 Step 3: Connect the positive and negative of the clamps to the
positive and negative of the car battery respectively (there will be a slight
spark during the conn
ection process, which is normal), and make sure
that the connection is good. At this time, the product display screen will
display the voltage of the jumpstarter in parallel with the car battery, and
the car can be started;
3.2.5 Short press the "Power" button to e
xit force start mode.
4.
How to Use the Voltmeter Function
4.1 Connect the clamps to the product EC8 jumpstart output port.
4.2 Connect the positive and negative of the clamps to the positive
and negative of
the car battery respectively, and make sure the
connection is good;
4.3 At this ti
me, the green light on the main interface will flash, and the
voltage of the Jumpstarter in parallel with the car battery will be
displayed. After entering the start mode, if you want to only check the
voltage of the car battery, short press the "Power" button to exit the start
mode, the Jumpstarter will enter the measurement mode, and then the
"green light" will go out, and the display only shows the voltage value of
the car battery.
4.4 Disconnect the jumpstarter clamps from the car battery and exit the
voltmeter function mode.
Product Specifications
Capacity：88,8 WH
Battery chemistry：Lithium-Ion
Starting voltage：12V Peak current：3000A
Jumpstarter clamps：RED（+） BLACK（-）
Charging temperature ：0℃~45℃
Storage temperature：-20℃~50℃
Operating temperature：-20℃~50℃
Output USB-A 5V/3A,9V/2A,12V/1.5A(18W MAX)
USB-C:5V/3A,9V/3A,12V/3A,15V/3A,20V/5A(100W MAX)
Input: DC 12V/5A (60W MAX)
USB-C:5V/3A,9V/3A,12V/3A,15V/3A,20V/5A(100W MAX)
Luminous flux：300Lumens
IP Code：IP65
To Next Page
Loading...
