LOKITHOR ja302 pro - Safety Instructions

Safety Instructions
Please read the following instructions carefully before using the Lokithor JA302 PRO jump
staer:
1. Please follow all instructions in this manual for safe Lokithor operation. Failure to follow all
instructions in this manual or improper use of Lokithor products may result in propey damage
and or personal inju.
2. Lokithor is designed for staing 12V engines and is not designed for staing vehicles exceeding
product specications in voltage or displacement.
3. Warning when using FORCED START mode all Lokithor safety features are disabled. Use extreme
caution: Do not allow the clamps to sho together or touch when using FORCED START mode.
Read and understand all safety procedures before using Forced Sta mode.
4. For best longevity of your Lokithor product we recommend a quaerly maintenance program.
Please fully charge your new Lokithor product when you receive it and eve 3 months inspect the
charge level of the device and charge if needed. Also you may use the power bank feature during
this time to discharge the batte to 50% or so and then recharge Lokithor to full before placing it
back in your vehicle. This good practice will help ensure you get the best product lifespan and that
Lokithor is always ready for the next emergency.
5. Do not use a damaged Lokithor. If your device has had impact damage, has been hit, dropped
or exposed to other physical damage do not use it. Using a damaged Lokithor may cause a
dangerous situation.
6. Do not attempt to use Lokithor while it is charging.
7. Please do not disassemble the jump staer. There are no user seiceable pas inside..
8. Use extra caution when working around car batteries and Jumpstaers. Avoid dropping metal
objects on batte terminals while using Lokithor. Any metal object can cause a dangerous sho
circuit condition. This may result in equipment damage and or explosion.
9. When staing a vehicle, ensure that the positive and negative cable clamps are in good contact
with the positive and negative terminals of the batte.
10. Do not allow sparks and or ames to contact the jump staer or engine. Always connect your
Lokithor to vehicle batte before attempting to power it on or Jumpsta a vehicle.
11. To prevent sho-circuit and sparks from damaging the jump staer, DO NOT clamp the positive
and negative poles of the cable clamps to each other and DO NOT connect clamps to the same
piece of metal(sho circuit).
12. Lokithor is not intended for use by children. Do not leave the jump staer in a place where
children can easily reach it.
13. Do not expose Lokithor to rain or snow.
14. Do not leave the Lokithor in extreme environments for long periods of time (extreme heat
above: >131℉ (55°C), or extreme cold below: <14℉ (-10°C), humidity: >80% humidity).
15. When not using Lokithor please store it in a cool d place.
16. Please ensure a good maintenance program for your Lokithor: Charge it in a timely fashion
after being used, or when it is in a discharged condition. Failure to do so may cause an
over-discharge condition leading to low internal batte voltage or an out of power condition.
Long periods of time with low or no power may cause permanent product failure.