Why does my Lombardini 25LD425-2 Engine start but then stop?
Your Lombardini Engine might start and then stop due to several potential issues: * Clogged pipes * Clogged fuel filter * Air inside fuel circuit * Clogged tank breather hole * Faulty fuel pump * Injector jammed * Jammed injection pump delivery valve * Wrong injector setting * Excessive plunger blow-by * Jammed injection pump delivery control * Wrong injection pump setting
What causes too low oil pressure in my Lombardini Engine?
Too low oil pressure in your Lombardini Engine could be caused by: * Oil level too high * Jammed pressure relief valve * Worn oil pump * Air inside oil suction pipe * Faulty pressure gauge or switch * Clogged oil suction pipe
General| Engine Model | 25LD425-2 |
|---|---|
| Category | Diesel Engine |
| Number of Cylinders | 2 |
| Fuel System | Direct injection |
| Engine Type | Four-stroke |
| Starting System | Electric |
| Bore x Stroke | 85 mm x 84 mm |
Lists potential engine failures and their corresponding causes and symptoms.
Explains the meaning of hazard symbols used in the manual.
Essential guidelines for safe engine operation and maintenance.
Specifies suitable oils and their ACEA/API classifications.
Important notes and safety precautions for disassembly.
Checks for piston ring wear, piston diameter, and pin clearances.
Procedures for checking connecting rod small end and big end clearances.
Checking crankshaft condition, oil passages, and journal dimensions.
Identifies components of the engine's fuel circuit.
Details checking, setting, and calibration of injection pumps.
Information on injector components, cleaning, and setting.
Steps for preparing the crankcase and fitting central main bearings.
Procedure for installing and timing the injection pumps.
To Next Page