Lombardini LDW 702 - General Engineering Drawings - Ldw 702-1003-1404; General Engineering Drawings - Ldw 1204-1204;T; General Engineering Drawings - Ldw 502-602-903; Power, Torque and Specific Fuel Consumption Curves Ldw 702-1003-1404

REG. CODE
1-5302-351
MODEL N°
50563
DATE OF ISSUE
04.90
REVISION 04
DATE
15.11.99
ENDORSED
COMPILER TECO/ATI
24
GENERAL
I
(D) Add fluid(s) as required
( • ) After inspection, adjust, repair or replace as required
(ž) Clean as often as required
(*) Replace air filter after air filter restriction switch indication or one(1) year. Lombardini does not
recommend the removal of air filter elements for purposes of inspection.
(**) Service oil bath filter element (upper and lower) as required. Replace reservoir oil as required.
NOTE: In dusty conditions, service the oil bath air filter every four(4) hours.
(***) Replace coolant every 1000 hours or 2 years
NOTES: 1. USE ONLY GENUINE LOMBARDINI REPLACEMENT PARTS.
2. USE ONLY LOMBARDINI APPROVED FLUIDS.
MAINTENANCE OPERATION
OIL LEVEL CHECK (D)
COOLANT LEVEL CHECK (D)
FAN/ ALTERNATOR BELT INSPECTION (•)
AIR FILTER ELEMENT CHECK (DRY TYPE) (*)
AIR FILTER CHECK (OIL BATH TYPE) (**)
RADIATOR CORE INSPECTION (ž)
FLUID LEAK INSPECTION- GENERAL (•)
SAFETY GUARD INSPECTION (•)
OIL REPLACEMENT- INITIAL ONLY-(see RECOMMENDED OIL TYPE)
OIL FILTER REPLACEMENT - INITIAL ONLY
OIL REPLACEMENT- (see RECOMMENDED OIL TYPE)
OIL FILTER REPLACEMENT
FUEL FILTER REPLACEMENT
COOLANT HOSE INSPECTION
FAN/ ALTERNATOR BELT TENSION ADJUSTMENT
VALVE ADJUSTMENT
FAN/ ALTERNATOR BELT REPLACEMENT
FUEL INJECTION SYSTEM ADJUSTMENT
CLEAN FUEL TANK
(ž)
COOLANT REPLACEMENT (***)
REPLACE TIMING BELT
MAINTENANCE INTERVAL
10
hours
or
DAILY
50
hours
125
hours
250
hours
500
hours
1000
hours
2500
hours
LDW- FOCS SERIES MAINTENANCE SCHEDULE
·
·
·
·
·
·
·
see note
·
·
·
·
·
·
·
·
·
·
·
·
·
Failure to carry out the operations described in the table may lead to technical damage to the machine
and/or system