MAINTENANCE
14
12. Measure the spark plug electrode gap with a suitable gauge.
The gap should be 0.028 - 0.031 in (0.70 - 0.80 mm). Correct
the gap, if necessary, by carefully bending the side electrode.
13. Install the spark plug carefully, by hand, to avoid cross-threading.
14. After the spark plug seats, tighten with a spark plug wrench to compress the water.
If reinstalling the used spark plug, tighten 1/8 - 1/4 turn after the spark plug seats.
If installing a new spark plug, tighten 1/2 turn after the spark plug seats.
CAUTION: A loose spark plug can overheat and damage the engine.
Over tightening the spark plug can damage the threads in the cylinder head.
15. Attach the spark plug cap.
To Next Page
Loading...
Need help?
General
