22
iv. Long storage of mini-tiller
If the mini tiller need be stored for a long time, the following measures should be taken to prevent rust and
erosion.
1. Seal up and store the engine as per requirements in the manual of engine.
2. Clean dirt and grime on the outer surface,
3. Drain lubricant from the transmission box and fill it with new lubricant.
4. Apply anti-corrosion oil on unpainted part of the non-aluminum-alloy surface.
5. Keep the product in a well ventilated, dry and safe indoor place.
6. Properly keep the tools, quality certificate and operation manual attached to the machine.
Chapter VI Adjustment method of mini tiller
i Method of adjusting reverse cable
When it is confirmed that the mini tiller’s reverse running is abnormal, the reverse shift handle and reverse
cable shall be adjusted right away, please refer to Chapter III for method of adjustment.
Note:
1. Grip firmly and release the reverse shift handle 2 to 3 times to confirm the working performance of gear
shifting operation, if it is abnormal, readjust the reverse shift handle and reverse cable until the gear shifting
operation is normal.
2. During running of the mini tiller, if you release the reverse shift handle, the reverse gear should be able
to return right away, and no abnormal of gear clashing should be heard from inside transmission box, if so, the
gears will be damaged.
ii. Method of adjusting clutch cable
When the mini tiller has been used for a period and its performance has worsen due to wear of friction
disks and clutch forks, the clutch cable should be adjusted; please refer to Chapter III for method of adjustment.
Note:
To Next Page
Loading...
Need help?
General
