LONCIN ATV110-M - Starting Out and Accelerating; Deceleration and Gear Shifting

To start out and accelerate:
1. Apply the rear brakes.
2. Release the throttle lever.
3. Shift into first gear then release the shift
pedal.
4. Release the rear brake.
5. Open the throttle gradually.
6. Once the engine has reached adequate
speed, release the throttle lever.
7. Shift into second gear then release the Shift
pedal.
8. Open the throttle gradually.
9. Follow the same procedure when shifting
To the third and fourth gears.
WARNING
Always release the shift pedal before open-
ing the throttle, or the engine could wheelie
and will cause an accident.
WARNING
POTENTIAL HAZARD
Apply a lower gear when the engine speed
is too high.
W
HAT CAN HAPPEN
The wheel could stop rotating. This could
cause an accident, loss of control, injury
and damage the engine.
H
OW TO AVOID THE HAZARD
Always shift to lower gear before you
make sure that the engine has sufficiently
slowed.
To decelerate:
1. Release the throttle.
2. Apply the brakes smoothly and evenly.
3. Shift to lower gear once the engine has
sufficiently slowed.
33