Clutch adjustment
1. Remove the rubber cap.
2. Release the locknut.
3. Slowly turn the adjusting bolt clockwise un-
til resistance is felt. Then turn it 1/8
counterclockwise.
4. Tighten the locknut to the specified torque.
5. Equip the rubber cap safely.
Cable inspection and lubrication
Lubricate the inner cables and the cable ends.
If the cables do not operate evenly, ask your
dealer to replace them.
Wheel removal
1. Raise the wheel by placing a suitable stand
under the frame.
2. Remove the bolts from the wheel.
3. Remove the wheel assembly
Wheel installation
When installing the wheel, reverse the re-
moval procedure.
Tighten the wheel bolts to the specified
torques.
49
To Next Page
Loading...
