Looxcie HD - Getting Started with Looxcie HD; Memory Card and Battery Setup; Device Charging; Software Downloads

2
CHARGE
Fully charge battery before first use.
1. Remove rubber rear panel cover. Confirm power switch is
in OFF position (closest to micro-USB port).
2. Plug USB Cable into camera’s micro-USB port.
3. Plug USB Cable into USB port on computer or AC adapter.
(Power switch blinks green.)
4. Power switch turns solid green when fully charged.
5. Replace rubber rear panel cover to ensure weather-resistance.
DOWNLOAD
LOOXCIEDESKTOP UTILITY (compatibility page 6)
Click here to install LooxcieDesktop for firmware updates
& transfering video to your computer.
1. Download, install & launch LooxcieDesktop on PC or Mac.
2. Slide camera power switch to ON position & connect to
computer via USB cable.
3. Install firmware updates if available.
4. Select “Manage” to copy or delete video clips & raw video buffer.
Note: To download raw video buffer, first copy & delete video clips.
LOOXCIE MOBILE APP (compatibility page 6)
Click here to download Looxcie mobile app for Android or iOS.
1. Download & launch Looxcie app on smartphone or tablet.
2. Setup Looxcie account & follow login steps.
3. Record & stream live video or watch friend & community videos.
Note: To live stream, connect to mobile network (3G or 4G).
BATTERY
1. Align metal prongs on battery & camera.
2. Insert front battery hooks into camera.
3. Close back of battery to lock in place.
4. To release battery, slide battery latch on
rear panel.
Note: Battery is replaceable.
SETUP
MEMORY CARD
1. Memory card is not included.
2. Slide silver slot toward USB port to unlock
and then lift to open (as shown below).
3. Insert card with metal prongs facing down
directly on top of metal prongs in slot.
4. Close slot & slide forward to lock in place.
Make sure card is seated properly.
(Card should lie flat.)
Note: Camera requires Class 4 (or higher)
microSDHC card & supports up to 32GB.
GETTING STARTED