Lorex LW1741AC1 - User Manual

www.lorextechnology.com
LW1741AC1_QSG_TRILINGUAL_R1 Page 1
ADD-ON CAMERA
LW1741AC1
QUICK START GUIDE
lorextechnology.com/support
x1 x3 x1
Attach the camera stand to the camera.
2
1
Use the included mounting screws to attach the
camera stand to the mounting surface:
a. Mark the positions of the screw holes on the mounting surface with
the base of the mounting stand.
b. Drill holes and insert the drywall anchors (included) as needed.
c. Firmly attach camera stand to the surface using the included screws.
Camera Setup
Before installing the camera, carefully plan where and
how it will be positioned, and where you will route the
cable that connects the camera to the power adapter.
4
Connect one end of the camera’s power adapter to
the camera and the other end to an electrical outlet.
Make sure the power connector is fully inserted to
avoid water getting in the plug.
5
Remove the protective film from the front of the
camera. If the film is not removed, it will affect
picture quality.
• Camera is rated for indoor/outdoor installation, but is not intended
for direct exposure to rain or snow. For outdoor applications, install
under shelter protected from the elements.
• Wireless cameras require a power source to operate.
• Ensure power outlets are sheltered from the elements.
Installation Tips
NOTE: If you run the power cable through the mounting surface,
connect power before attaching the camera to the wall.
Press on the receiver to enter the main menu.
2
1
Connect the new camera
to a power outlet. Place the
camera within 1ft of the
wireless receiver.
Pairing the Camera with the Receiver
3
Select Camera Setting and press
OK
to confirm.
What’s Included
6
NOTE: If you pair a new camera to a channel that is already being
used by an existing camera, the new camera will be connected to
that channel. The old camera will automatically be disconnected.
Following the on-screen prompt,
you have 30 seconds to press
the Pair button on the camera.
If pairing was successful, the pairing
channel shows the statement PAIR OK.
NOTE: If you do not press the Pair button on the camera during
the 30 second pairing window, repeat steps 2~6 to try the pairing
process again.
NOTE: If the speaker begins squealing, move the camera and
receiver away from each other.
1ft
OK
Pair
Pair
Press repeatedly to return to live view to see the camera’s video
feed displayed on-screen.
OK
4
Select Pairing and press
OK
to
confirm.
5
Use the arrow keys on the receiver to
select the channel you want to pair
the camera to. Press
OK
on the
desired channel to begin pairing.
3
Loosen the adjustment ring
on the metal camera stand
and move the camera to the
desired position.
Tighten the adjustment ring
when finished, holding the
camera firmly in position.
Adjustment ring

Summary

Camera Setup and Installation

Initial Setup and Connection

Connect the new camera to power and place it near the wireless receiver.

Physical Mounting Guide

Steps for attaching the camera stand and positioning the camera securely.

Final Setup Checks

Connect the power adapter and remove protective film for optimal picture quality.

Pairing Camera with Receiver

Initiate Pairing Process

Select Camera Setting and Pairing options on the receiver to start the process.

Channel Selection and Confirmation

Choose a channel on the receiver and press the camera's Pair button within 30 seconds.

Verify Pairing Status

Confirm successful pairing by checking for the 'PAIR OK' message on screen.

Troubleshooting Pairing

Repeat pairing steps if unsuccessful or if audio interference occurs.

Lorex LW1741AC1 Specifications

General

Brand	Lorex
Model	LW1741AC1
Category	Security Camera
Language	English