Attach the cord to the eye of the sides of a shaft. Use the knot shown in the
picture, created as follows: insert the cord from the inside, where the eye
has a sharp edge, and wrap the tail around the notch, tucking the cord so
that it crosses on the outside.
Adjust the position of the shaft as
shown in the picture by changing
the length of the nylon cord. The
distance between the elastic cord
and the bottom of the shaft should
be about 8 mm (5/16”). You can
adjust the shafts more precisely,
later on.
Now, attach a second shaft cord
to the next toggle and lead it
through in between the hinges
and the rollers.
To Next Page
Loading...