Again, lead the cord ends to both
sides, as before. The picture
shows how one cord end runs in
front of the pair of rollers used by
the cord installed previously.
Continue this procedure for each
shaft. After you have connected
all shafts with their toggles, the
cords will form the pattern shown
in the picture.
Turn the loom right-side-up and check the level of the shafts. The clearance
between the bottom of the shafts and the table surface should be about
18mm (3/4”)
To shorten the cord, pull it while moving the end back and forth as shown
on the left picture. The right picture shows how to lengthen the cord; lift the
shaft to isolate the cord and use your nail to pull the end of the cord back.
To Next Page
Loading...