EasyManua.ls Logo

Lovol TE254 - Page 11

Default Icon
104 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Safety Precautions
Application of fuel
1. The fuel is flammable, and shall be refilled in the places far away from
Fire source.
2. Prior to refilling fuel tank, turn off the engine.
3. Don’t smoke and be close to fire when refilling and repairing fuel system.
4.
Keep machine clean without dirt, grease, or debris; When fuel and oil
overflow, wipe them out with a clean cloth.
5. The quality of fuel and grease should meet the requirements as specified in
“Appendix” section.
Fig. 1-4 Application of fuel
Safety replacement of operating oil
1.
The working fluid is dangerous and can cause serious injuries, such as high pressure hydraulic oil, brake
fluid, engine oil, etc.
2. Shut off the engine before replacing working fluid. No fire and
no smoking; Use a cloth to wipe up the oil
when it overflows.
3. Replace operating oil with those at specified grade.
4. The used operating oil is waste oil and can not be thrown away.
Tire maintenance precautions
1. In case of installation and removal of tire, it is easy to cause explosion if you fail to operate as specified in
the manual. This can cause serious injury or even death; never install or disassemble the tires till you have
obtained proper and safety operation experience.
2. Make sure
inflation pressure for tire is correct; the maximum inflation pressure cannot exceed specified
value. If this is the case, there will appear some crack threads on the edge of the tire, even such can cause
explosion accident. When the inflation pressure has reached recommended value, deflation is required if both
sides of tire have not positioned yet. Inflate again after the tire is re-fixed and the edge is lubricated.
3. Regular check and tighten torques of locknuts and bolts on the front and rear wheel rims, in order to avoid
machine from rollover caused by disengagement of wheel during operation, and protect operator from
serious injury and eliminate excessive damage to the machine.
Disposed oil and waster placement
1. Improper disposal of used oil and
wasters can cause great threat to
ecological environment.
2. Leak-
proof container shall be used for disposed oil emission; never use
food and beverage containers to prevent others mistake swallow, resulting
in accidental injury.
3. Don’t dump used oil o
n the ground, into subway or discharge them into
other water sources.
4.
Don’t dispose arbitrarily used oil, fuel, refrigerant, brake fluid, filter
elements or batteries, which can be hazardous; more information for
reusing or disposing wasters in a right
way, contact local environmental
protection department or recycle center.
Fig. 1-5 Waster placement
2

Table of Contents

Related product manuals