Safety Precautions
Underway of living and industrial electricity cables
1. Make sure to secure all machine parts to prevent them loosening and electric shock.
2. When driving through under living and industrial electricity cables at low speed, make sure the maximum
height falls into the range of cable safety values as required to avoid electric shock caused by hooking or
touching with cables.
3. Prevent risk of electric shock from touch with high voltage wires during transportation, operation and in
shutoff state.
Correct support for tractor
1. To descent the parts or tools onto the ground, the tractor and its parts
needed to be lifted shall be supported safely.
2. Do
n’t use cinders, bricks (hollow) or other fragile substance under
continued pressure to support machine.
3. Don’t operate tractor in the case only having a jack is used for support
tractor.
4. Before operating jack, you should read through the user manual
carefully. Never overloading, this is the case only if rigid support deck
is stalled to avoid injury and property losses.
5. When using jack, only use it for support right under left and right axle
shaft housing of rear axle and front bracket, no need to support other
parts.
Fig. 1-6 Support risk
Fig. 1-7 Jack support parts
1.Front bracket;
2.Left axle shaft shell;
3.Right axle shaft shell
Cab emergency exit
There are three emergence exits in the cab, left door, right door an
d rear window. In the case of emergence, lift
unlock handle to open the doors or rotate opening handle clockwise to open rear window and leave the cab safely.
Avoid touch with moving parts
1. When the machine is running, never carry out lubrication, maintenance,
service or adjustment operations until its shutdown.
2. Make hands, feet and clothes away from moving drive components.
Fig. 1-8 Avoid touch with
moving parts
3
To Next Page
Loading...
