What causes triggering of general system protection in Lowara Water Pump?
If the general system protection of your Lowara Water Pump is triggered, it might be due to a short circuit. Check the connection cables to resolve this.
Why does Lowara Water Pump trigger differential system protection?
If the differential system protection (circuit breaker) is triggered in your Lowara Water Pump, it indicates a ground leakage. Check the insulation of the electric pump and cables.
How to fix Lowara Water Pump that does not start?
If your Lowara Water Pump isn't starting, first ensure it has a power supply by restoring it if necessary. Also, check if the magneto-thermal switch has been triggered and reset it if needed.
What to do if Lowara Water Pump does not start or stops?
If your Lowara Water Pump stops or doesn't start, several issues could be the cause: * **Motor Overload or Overtemperature:** Check the working conditions of the electric pump. * **Damaged Motor Stator:** Inspect the motor for damage. * **Converter Overtemperature:** Ensure proper cooling of the converter is not obstructed. * **Dry Running:** Verify the water level. * **Pressure Transmitter Problems:** Examine the transmitter and its connection cable.
Why does Lowara Water Pump speed fluctuate cyclically?
If your Lowara Water Pump's speed cyclically increases and decreases, it could be due to: * **Water Leaks:** Check the system for leaks in the non-return valve or elsewhere. Repair or replace any faulty components. * **Undersized Surge Tank:** Check the working conditions of the electric pump. * **Ruptured Surge Tank Diaphragm:** Replace the diaphragm. * **Incorrect Work Point Setting:** Modify the system settings to be suitable.
Why does Lowara Water Pump start and stop frequently?
Frequent starting and stopping of your Lowara Water Pump may be due to problems with the float switch in the suction tank. Check the float switch and the tank.
What to do if Lowara Water Pump runs at maximum speed?
If your Lowara Water Pump is always running at maximum speed, there may be problems with the pressure transmitter. Check the hydraulic connection between the transmitter and the system.
How to reduce vibrations in Lowara Water Pump?
Vibrations in or near your Lowara Water Pump can occur if the work point setting is not suitable for the system, specifically if the value is lower than the minimum pressure that the pump can deliver. Modify the system settings to correct this.
Why Lowara Water Pump does not start after setting work point to zero?
If your Lowara Water Pump doesn't start, it could be due to a work point setting that is unsuitable for the system, specifically if the value is equal to zero. Modify the system settings to resolve this.
Details how to connect the unit's power supply safely and correctly.
Describes the wiring procedures within the electrical control panel.
Instructions on how to adjust the system to a higher pressure setting.
Instructions on how to adjust the system to a lower pressure setting.
General| Brand | Lowara |
|---|---|
| Model | TKS Series |
| Category | Water Pump |
| Language | English |
To Next Page
