39
Fuel Management highlighted on Networking menu (left). Fuel
Management menu (right).
Fuel Management Menu
The Fuel Management menu gives you access to the following options:
Tank Location, Fuel Added, Add Fuel, Fill Tank, Engine Select, Reset
Calibration, Reset Trip and Reset Seasonal. The menu is divided into two
parts: Tank Operations and Engine Operations. You will calibrate your
fuel flow from Tank Operations section of the Fuel Management menu.
Engine Operations are located in the lower half of the menu.
Tank Operations
The top half of the Fuel Management menu covers Tank Operations,
which include Tank Location, Fuel Added, Add Fuel and Fill Tank.
Adding Fuel to Tank
Tank Location, Fuel Added and Add Fuel commands work together to
keep NMEA 2000 fuel data consistent with the actual amount of fuel
added to the fuel tank(s).
1. Press
MENU twice, select NMEA 2000 or NETWORKING and press ENTER.
2. A menu will appear with five options: Bus Setup, Fuel Management,
NMEA 2000 Alarms, Waypoint Sharing and Backlight
Synchronization. Select
FUEL MANAGEMENT and press ENTER.
3. Highlight
TANK LOCATION and press ENTER. The Tank Location menu
will appear.
4. Select the tank you added fuel to and press
ENTER.
5. Follow the steps below that apply to your tank.
To Next Page
Loading...
Need help?
General
