42
To Reset Calibration:
Choosing the Reset Calibration command will switch fuel flow
calibration settings back to factory defaults.
1. Press
MENU twice, select NMEA 2000 or NETWORKING and press ENTER.
2. Highlight FUEL MANAGEMENT and press ENTER. 3. Highlight to ENGINE
SELECT and press ENTER. Select the desired engine and press ENTER.
4. Highlight
RESET CALIBRATION and press ENTER. The following
confirmation message will appear: Are you sure you wish to Reset
Calibration? Select
YES and press ENTER. Calibration settings for the
selected fuel have been returned to factory defaults.
To Reset Trip:
The Reset Trip function allows you to reset to zero the running total of
fuel used on a particular trip.
1. Press
MENU twice, select NMEA 2000 or NETWORKING and press ENTER.
2. Highlight
FUEL MANAGEMENT and press ENTER. The Fuel Management
menu will appear.
3. To reset trip fuel used for a particular engine, highlight
ENGINE SELECT
and press
ENTER. Select the desired engine or All Engines and press
ENTER.
4. Highlight
RESET TRIP and press ENTER. The following confirmation
message will appear: Are you sure you wish to Reset Trip?
5. Highlight
YES and press ENTER. The Trip Fuel Used figure has been
reset to zero.
To Reset Seasonal:
Your unit can track fuel usage not only for trips, but also for entire
seasons. The reset seasonal command allows you to reset to zero the
running total of fuel used during a season.
1. Press
MENU twice, select NMEA 2000 or NETWORKING and press ENTER.
2. Highlight
FUEL MANAGEMENT and press ENTER.
3. To reset seasonal trip fuel used for a particular engine, highlight
ENGINE SELECT and press ENTER. Select the desired engine or All Engines
and press
ENTER.
4. Highlight
RESET SEASONAL and press ENTER. The following
confirmation message will appear: Are you sure you wish to Reset
Seasonal?
5. Highlight
YES and press ENTER. The Seasonal Fuel Used figure has
been reset to zero.
To Next Page
Loading...
Need help?
General
