1
HDS unit installation instructions
988-0176-06_A
Read the following instructions carefully before attempting any installation.
Transducer installation recommended tools and supplies
(not included)
If you plan to route the transducer cable through the transom, you will need either
a 1" drill bit or a 5/8" drill bit depending on the size of the transducer cable con-
nector. Each transom mount requires a high quality, marine grade above- or below-
waterline sealant/adhesive compound. The following installations also call for these
recommended tools and supplies.
One-piece bracket transom installation:
Tools: two adjustable wrenches or socket wrench, drill, #29 (0.136") drill bit, screw-
driver. Supplies: none.
Two-piece bracket transom installation:
Tools: two adjustable wrenches or socket wrench, drill, #20 (0.161") drill
bit, screwdriver. Supplies: four, 1" long, #12 stainless steel wood screws.
TMB-S bracket trolling motor installation:
Tools: two adjustable wrenches or socket wrench, screwdriver. Supplies:
plastic cable ties.
Skimmer Transducer shoot-through hull installation:
Supplies: alcohol wipes, 60 and 160 grit sandpaper, and marine grade
above- or below-waterline epoxy adhesive.
Pod Transducer shoot-through hull installation:
Supplies: alcohol wipes, 60 and 160 grit sandpaper, and marine grade
above- or below-waterline epoxy adhesive.
To Next Page
Need help?
General
