Need help?Do you have a question about the Lowrance HDS PRO and is the answer not in the manual?
General| Networking | Ethernet, NMEA 2000 |
|---|---|
| Connectivity | Wi-Fi, Bluetooth |
| Waterproof Rating | IPX7 |
| Sonar | CHIRP |
| Memory Card Slot | 2 Micro SD card slots |
| Operating System | Lowrance Operating System |
| Display Size | 9-inch, 10-inch, 12-inch, 16-inch |
| Operating Voltage | 12 V DC (10.8-17V DC) |
Explains the function of each button on the front panel of the HDS Pro unit.
Provides crucial advice on selecting a safe and optimal location for unit installation.
Step-by-step instructions for mounting the unit using a gimbal bracket.
Offers essential safety and best practice recommendations for cable installation.
Explains the setup and guidelines for planning and installing an NMEA 2000® network.
Details how to connect network devices to the unit via Ethernet ports.
Describes the main screen, accessed by a short press on the home key.
Details the procedures for powering the unit on, off, and entering standby mode.
Explains how to save a Man Overboard (MOB) waypoint in emergency situations.
Details the calibration process for accurate fuel flow measurement.
Describes how to configure the quick access keys and the home key.
Defines waypoints and explains how to save them at specific locations.
Explains how to create, edit, and delete routes using routepoints.
Explains how to start, stop, and configure sonar data logging.
Provides safety guidelines and warnings for operating the autopilot.
Explains the controls and buttons used for the trolling motor autopilot.
Describes the controls and buttons for the outboard motor autopilot.
Covers steering response, NAC-2/NAC-3 settings, and rudder gain.
Explains how to improve radar images by adjusting gain, clutter, and sensitivity.
Covers settings for symbology, bearings, data bar, and dangerous targets.
Explains MARPA target symbols and tracking capabilities.
Introduces AIS system, target display, and collision avoidance.
Explains AIS SART activation, data reception, and alarm messages.
Details how to define alarms for target proximity and target loss.
Details configuring and operating the optional LR-1 wireless remote.
Explains how the system checks for dangerous situations and system faults.
Guides on updating the unit's software via internet or storage device.
Provides detailed technical specifications for the HDS Pro unit.
Specifies supply voltage, power consumption, and fuse ratings.
Lists ports for NMEA 2000®, NMEA 0183®, Sonar, HDMI®, Ethernet, USB, and data cards.
To Next Page
