133
Transfer My Data highlighted (left). When transferring data (right)
you will have the option of transferring the unit's data to a MMC card
or loading the data on the MMC card into the unit.
3. Saving to MMC: To accept the default name "Data" for the GPS
Data File, press ↓ to
SAVE DATA|ENT. If you want to rename the file (as
shown in the following figures), press
ENT to activate the selection box.
Press ↑ or ↓ to change the first character, then press → to the next
character and repeat until the name is correct. Then, press
ENT|↓ to
SAVE DATA|ENT.
The unit will display first a progress message followed by a completion
message when the data transfer is finished. To return to the Page view,
repeatedly press
EXIT.
These figures (left to right) show the menu sequence for naming and
saving a GPS Data File from the unit's memory to an MMC.
4. Loading to unit memory: There may be more than one GPS Data
File (*.USR) on the card. To select a file, press
ENT to activate the se-
lection box, use ↓ or ↑ to highlight the file, then press
ENT to accept the
selection. Next, press ↓ to
LOAD DATA|ENT. The unit will display a com-
pletion message when the data transfer is finished. To return to the
Page view, press
EXIT repeatedly.
To Next Page
Loading...
Need help?
General
