1
StructureScan Installation
Accessories
If you received this manual with a StructureScan accessory, you will notice that
some information in the document does not apply to the accessory. This manual has
installation instructions for your accessory, and accessory pack content tables on the
back cover.
Contents
Your StructureScan box is packed with the LSS-1 black box, a Power cable, fuse
and fuse holder, StructureScan transducer, mounting bracket, 15 foot (4.5m) ethernet
cable and a hardware kit. The transducer has a 20 foot (6m) cable attached.
Hardware Mounting Kit (Included)
Transom mount screws (2)
Transducer attachment lock
nuts (6)
Bracket Assembly bolts (2) LSS-1 Mounting screws (4)
Bracket Assembly washers (4) Closed end crimp connector (1)
Bracket Assembly nuts (2) Zip ties (2)
Transducer attachment screws (6)
Required Tools and Supplies (Not Included)
Drill Phillips (slotted-head) screwdriver
Drill bits
Marine grade above- or below-
waterline sealant
LSS-1 module, ethernet cable, StructureScan transducer, transducer
mounting bracket and power cable.
To Next Page
