5 -13
The jacking points for maintenance is depending
on serviced parts case by case. Do not hesitate
to contact your authorized dealer for asking.
Do not use the front axle assembly or steering
linkage and cylinder for jacking point. These
components have some rotating pivots and/or
does not have enough structural strength.
For general maintenance, use a flat surface
under the engine frame end or bumper for
jacking point, and additionally connect the front
towing hook to the hoist for safety.
For rear jacking points, two flat surfaces under
the rear axle housing is recommended, and
additionally use the top-link bracket and its pin
for lifting point after removing the upper link.
② Jacking points
Front jacking point
▶When lifting the rear of the
tractor, apply chocks to the slots
between front axle and engine
frame symmetrically to prevent
the tractor from rolling.
Caution
Rear jacking point
Rear jacking point
Upper link pin
Upper link
Front ballast weights
Bumper
To Next Page
Loading...
