5 -28
Unscrew the two bolts④ and rotate the clutch
arm③ counter-clockwise by 2.5 degrees.
Assemble the two bolts④ with washers and nuts
⑤ into the next assembly holes counter-
clockwise from the previous attached holes.
Tighten the two bolts.
Tightening torque: 34~39 N.m (25~29 lb-ft)
Note: This rule must be adapted when you
adjust the clutch arm next times.
3
4
5
Clutch arm assembly
2
“H”
▶If the clutch arm assembly is not adjusted on time, it may cause a rapid/earlier
clutch disk abrasion and damage of the synchro-mech gears.
Caution
Assemble the clutch arm assembly to the tractor
in the reverse order of disassembly, and tighten
the bolt②.
Check if the height(“H”) of the clutch arm from
the valve block is about 35~36mm after
adjustment.
New assembly hole
Counter-clockwise
To Next Page
Loading...
