BACKHOE REMOVAL
WARNING : CAUTION :
CAUTION :
WARNING :
CAUTION :
DANGER :
CAUTION : WARNING :
Backhoe Removal
Before removing the backhoe, make sure the
swing lock pin locked in position.
Move the backhoe to flat, firm and wide
place to remove the equipment.
Do not allow to be removed without bucket
and stabilizers. Also, Dump the remaining material
from the bucket to empty.
Use other lifting equipment to remove when
the backhoe has damage.
Before starting the engine of your tractor,
make sure all operating controls are in park lock or
neutral position.
Operate controls only when seated in the
operator's seat.
Never allow any part of body under the
machine and between tractor and backhoe.
Before leaving the backhoe operator's seat,
fully lower the boom to the ground.
STEP 1.
Move the tractor to backhoe storage place.
STEP 3.
Center the boom and then lock the swing with swing
lock pin.
STEP 2.
Use the inner two levers to lower the stabilizers until
they contact to the ground. Use the boom and
dipperstick control lever to raise the boom &
dipperstick completely.
- 23 -
To Next Page
Loading...
Need help?
General
