LSIS S100 Installation Manual

S100/H100 Conduit Option Installation Manual
WARNING
 Do not remove the cover while power is applied or the unit is in
operation.
Otherwise, electric shock could occur.
 Do not run the inverter with the front cover removed.
Otherwise, you may get an electric shock due to high voltage terminals or charged capacitor
exposure.
 Do not remove the cover except for periodic inspections or wiring, even
if the input power is not applied.
Otherwise, you may access the charged circuits and get an electric shock.
 Wiring and periodic inspections should be performed at least 10 minutes
after disconnecting the input power and after checking the DC link
voltage is discharged with a meter (below DC 30V).
Otherwise, you may get an electric shock.
 Operate switches with dry hands.
Otherwise, you may get an electric shock.
 Do not use the cable when its insulation is damaged.
Otherwise, you may get an electric shock.
 Do not subject the cables to scratches, excessive stress, heavy loads or
pinching.
Otherwise, you may get an electric shock.
3

LSIS S100 Specifications

General

Brand	LSIS
Model	S100
Category	DC Drives
Language	English