LSIS SV008iC5-1 - User Manual

Important User Information
i
Thank you for purchasing LS Variable Frequency Drives!
SAFETY INSTRUCTIONS
 Always follow safety instructions to prevent accidents and potential hazards
from occurring.
 In this manual, safety messages are classified as follows:
WARNING
Improper operation may result in serious personal injury or
death.
CAUTION
Improper operation may result in slight to medium personal
injury or property damage.
 Throughout this manual we use the following two illustrations to make you
aware of safety considerations:
Identifies potential hazards under certain conditions. Read the message
and follow the instructions carefully.
Identifies shock hazards under certain conditions. Particular attention
should be directed because dangerous voltage may be present.
 Keep operating instructions handy for quick reference.
 Read this manual carefully to maximize the performance of SV-iC5 series
inverter and ensure its safe use.
WARNING
 Do not remove the cover while power is applied or the unit is in operation.
Otherwise, electric shock could occur.
 Do not run the inverter with the front cover removed.
Otherwise, you may get an electric shock due to high voltage terminals or
charged capacitor exposure.
 Do not remove the cover except for periodic inspections or wiring, even if
the input power is not applied.
Otherwise, you may access the charged circuits and get an electric shock.
 Wiring and periodic inspections should be performed at least 10 minutes
after disconnecting the input power and after checking the DC link
voltage is discharged with a meter (below DC 30V).
Otherwise, you may get an electric shock.
 Operate the switches with dry hands.
Otherwise, you may get an electric shock.

Summary

Safety Instructions

WARNING

Describes potential for serious personal injury or death.

CAUTION

Describes potential for slight to medium injury or property damage.

General Safety Precautions

Specific Safety Warnings

Critical safety directives for operation.

Operating Precautions

Handling and installation

Precautions for physical handling and setup.

Wiring

Instructions and considerations for electrical connections.

Operation precautions

Basic Information and Precautions

Important Precautions

Unpacking, inspection, accessories, and initial checks.

Installation

Installation Precautions

Environmental, mounting, and clearance requirements.

Wiring

Terminal Wiring

Detailed diagram of all electrical connection terminals.

Specifications for Power Terminal Block Wiring

I;O terminal Block Specification

Basic Configuration

Connection of Peripheral Devices to the Inverter

Required external components and their setup.

Recommended MCCB, Earth Leakage Circuit Breaker (ELB) and Magnetic Contactor Specification

Programming Keypad

Keypad Features

How to change the codes in a group

Parameter Setting Method

Detailed procedures for adjusting parameter values.

Monitoring of Operation Status

Basic Operation

Frequency Setting and Basic Operation

Initial setup and running the inverter.

Function List

Drive Group

Function Group 1

Function Group 2

Troubleshooting and Maintenance

Protective Functions

List of fault codes and their descriptions.

Fault Remedy

Causes and solutions for inverter faults.

Precautions for Maintenance and Inspection

Safety guidelines before performing service.

Check Points

Specifications

Technical Data

EMC INSTALLATION GUIDE

UL Marking

LSIS SV008iC5-1 Specifications

General

Brand	LSIS
Model	SV008iC5-1
Category	DC Drives
Language	English