LSIS SV008iC5-1 - Monitoring of Operation Status

5. Programming Keypad
5-10
5.6 Monitoring of Operation Status
Monitoring output current in Drive group
Drive group
1
-. In [0.0], continue pressing the Up () or Down () key
until [Cur] is displayed.
2
-. Monitoring output current is provided in this parameter.
-. Press the Prog / Ent (

) key once to check the current.
3
-. Present output current is 5.0 A.
-. Press the Prog / Ent (
) key once to return to the
parameter name.
4
-. Return to the output current monitoring code.
♣ Other parameters in Drive group such as dCL (Inverter DC link current) or
vOL (Inverter output voltage) can be monitored via the same method.