Technical Specification
Camera
Operating Voltage range 12V DC
Current consumption < 150mA
Image Sensor CMOS
No. of pixel 640X480
Resolution
350
Optical Lens 2.4 mm / F2.0
Camera View Angle 120 degree
Wireless Transmitter
Transmission Frequency 2414 MHz
RF transmission distance (open space) > 30M
LCD monitor
Operation Voltage 12 DC
Standby Current < 30mA
Operation Current < 350mA
LCD display screen size 3.5
No. of pixel 480x234
Viewing angle 90
Operation Temperature -10 to + 45
o
C
Storage Temperature -30 to + 80
o
C
TESTING THE SYSTEM
1. Reattach the vehicle’s negative battery cable.
2. Turn the ignition key to the accessory position, do not start the vehicle.
3. Engage the parking brake, put the shifter in the reverse position.
4. Look at the monitor, if the image does not match your rear view mirror press the Image
Orientation button on the monitor to correct the image.
After testing the unit and you are satisfied with the route you have chosen for the cabling, you
must permanently install it.
Fully tighten the license plate bolts.
Route all wires behind interior panels or under carpeting so they are hidden.
Use supplied cable ties to neatly gather any excess wire.
16
To Previous Page
Loading...