Need help?Do you have a question about the LTS LTH-M201-C and is the answer not in the manual?
General| Video Compression | H.264 |
|---|---|
| Tamper-Resistant | Yes |
| Camera Resolution | 2MP |
| Max. Resolution | 1920x1080 |
| Video Frame Rate | 30fps |
| Audio Compression | G.711 |
| Audio Input | Built-in microphone |
| Audio Output | Built-in speaker |
| Wired Network | 10/100M Ethernet |
| Power Supply | 12 VDC |
| Type | Video intercom |
| Communication | TCP/IP |
Details FCC compliance and rules for digital devices.
Explains CE marking and directives for product compliance.
Lists critical warnings for preventing serious injury or death.
Outlines precautions to prevent potential injury or equipment damage.
Describes the function of each terminal and interface on the main unit.
Provides diagrams and explanations for connecting door locks, magnetic sensors, and exit buttons.
Explains the wiring procedure for door lock mechanisms.
Details the connection for door magnetic sensors.
Explains the wiring for exit buttons.
Instructions for setting the sub module address using DIP switches before installation.
Details general procedures for installing a single module unit.
Step-by-step guide for surface mounting a single module unit.
Step-by-step guide for flush mounting a single module unit.
Details general procedures for installing a two-module unit.
Step-by-step guide for surface mounting a two-module unit.
Step-by-step guide for flush mounting a two-module unit.
Details general procedures for installing a three-module unit.
Step-by-step guide for surface mounting a three-module unit.
Step-by-step guide for flush mounting a three-module unit.
Details general procedures for installing units with more than three modules.
Step-by-step guide for surface mounting units with more than three modules.
Step-by-step guide for flush mounting units with more than three modules.
Steps to activate the door station using NVMS7000 software.
How to modify the device's IP address and gateway via NVMS7000.
Process for adding the activated device to the NVMS7000 client list.
Instructions for initiating calls to residents from the main unit.
Specific steps for making calls directly from the main unit.
To Next Page
