Lucent Technologies DACS II - GT 1.2: Deactivating a Remote Loopback Test; When to Use; Before You Begin; Related Tasks

Issue 2.0 April 2000
1-7
365-353-255
DACS II Operation and Maintenance Manual
Release 8.2.6 Features
GT 1.2: Deactivating a Remote
Loopback Test
When to use
Use this task to deactivate a remote loopback test.
Before you begin
You must have an existing remote loopback test in progress.
Related Tasks
For related tasks, refer to GT 1.1: Activating a Remote Loopback Test.
Ta s k
To deactivate a remote loopback, enter the following command:
RLS-LPBK-{T1|E1}::npcNo.::loop:locn;
Where:
Stop! End of Task.
RLS-LPBK-{T1|E1}
Release loopback for a:
T1
1.544 Mb/s signal
E1
2.048 Mb/s signal
loop
Loopback type:
loop Explanation
LINE
Line
npcNo.
NPC number
locn
Loopback location:
locn Explanation
FEND
Far-end