Issue 2.0 April 2000
1-9
365-353-255
DACS II Operation and Maintenance Manual
Release 8.2.6 Features
GT 1.3: Changing the Delay for DS3
Alarm Messages
When to use
Use this task to change the delay (alarm activate integration) time for issuing
DS3 alarms. This delay is the duration between the onset of the DS3 failure and
the time when the alarm is displayed.
This command can be completed even if the HDS3U is unequipped or
Out-of-Service.
NOTE:
This command can only be performed by the Frame Administrator or by a
user with Frame Administration privileges.
NOTE:
This command sets the DS3 alarm delay for the entire frame.
Related Tasks
For related tasks, refer to:
■ GT 1.4: Querying the Delay for DS3 Alarm Messages
Ta s k
To change the delay time of DS3 alarm message reporting, enter the following
command:
ED-PRMTR-T3::::DS3ALMDLY:[x]x;
Where:
Stop! End of Task.
ED-PRMTR-T3
Change
DS3ALMDLY
Delay time for DS3 alarm message output
[x]x
Delay time; any whole number between 2 and 10
seconds. Default: 10 seconds
To Next Page
Loading...
Need help?
General