DACS II/Rel 8.2.6 April 2000
2-13
DACS II/Rel 8.2.6
MML
RLS,LPBK,T1,E1
26151
FACILITY LOOPBACK RELEASE
MML
26151
RLS,LPBK,T1,E1
Explanation of
Command
For TA type NPCs on DS3Us
ANSI (American National Standards Institute) T1.403 is a DS1 interface
specification, which among other things, specifies the use of the4kb/s ESF
data link for network maintenance. The data link is used to communicate
between network elements which transport the DS1 facility.
This command is used to deactivate near-end (at the DACS II) and far-end (at the
terminal on the other end of the DS1 facility) loopbacks on ESF formatted facilities
as defined by ANSI T1.403.
This command can be used to deactivate a DACS II near-end payload loopback or
to cause DACS II to transmit payload or line loopback deactivate commands on
the ESF data link to far-end equipment, ordering the equipment on the other end
of the DS1 facility to deactivate the respective loopbacks.
For TE and TH type NPCs on Hybrid DS3Us
This command can also be used to release a line loopback towards the facility
of a DS1 circuit of type TE or of an E1 circuit of type TH within a Hybrid DS3. In
addition, it can be used to release a remote line loopback on a distant multiplexer.
(See command I.26141 to activate such loopbacks.)
Command Nonhierarchical
[I.26151]
RLS-LPBK-T1:[<xy>]:[s]abc:[ww]:loop[t]:locn;
The following applies to E1 circuits multiplexed within a Hybrid DS3
only
[I.26151]
RLS-LPBK-E1:[<xy>]:[s]abc:[ww]:loop[t]:locn;
To Next Page
Loading...
Need help?
General