Lumberjack PR12 - Assembly and Setup; Fitting and Removing a Cutter

9
Assembly
Avoidunintentionalstartingofthemachine.
Duringassemblyandforallworkonthe
machine,thepowerplugmustnotbe
connectedtothemainssupply.
Carefullyremoveallpartsincludedinthe
deliveryfromtheirpackaging.
Removeallpackagingmaterialfromthe
machineandtheaccessoriesprovided.
Beforestartingthe
operationofthemachine
forthefirsttime,checkifallpartslistedin
theboxcontentsectionhavebeensupplied
Note:Checkthepowertoolforpossible
damage.Beforefurtheruseofthemachine,
checkthatallprotectivedevicesarefully
functional.Anylightlydamagedpartsmust
becarefully
checkedtoensureflawless
operationofthetool.Allpartsmustbe
properlymountedandallconditionsfulfilled
thatensurefaultlessoperation.
Damagedprotectivedevicesandpartsmust
beimmediatelyreplacedbyanauthorised
servicecentre.
Warning–Donottightenthecollet
withoutacutterfitted.
Warning–Alwaysusecutterswith
shanksthatmatchthediameterofthe
collet.

Caution–Pleasetakeextracarewhen
fittingorremovingacuttertoavoid
cuts.
FittingandRemovingaCutter
FittingCutters–
‐LoosentheColletnutusingthetool
provided.