English - 28
cannot be
displayed when
the setting is
updated
Method 2: Please follow the steps of 6.1.1 Manual
connection for reconnection
Method 3: Please press and hold the DC-W50 [Reset]
button for 5 seconds. After restarting, please follow the
steps of Chapter 6 Start Using
for reconnection.
If the problem still occurs, please contact your distributor.
9 The
corresponding
DC-W50 cannot
be identified
when two or
more DC-W50s
are connected
Please follow the steps of 6.1.3 Change the SSID
to
modify the SSID.
10 If you forget the
password and
cannot log in the
administrator
webpage
Please press and hold the DC-W50 [Reset] button for 5
seconds and restore the factory default values.
11 What if the signal
is weaker?
1. Please adjust the place of DC-W50 to obtain better
connection quality.
2. Please go to the administrator webpage and set
DC-W50 at different channel frequencies so as to
avoid the interference of signal transmission.
12 The customer
DC-W50 cannot
be found when
using Ladibug
software
Please reset customer DC-W50 (press the DC-W50 [Reset]
button for 5 seconds till restarting is completed), and reset
in accordance with the 8.3.2 customer DC-W50 settings
,
and resume operation.
To Previous Page
Loading...
Need help?
General