Installation before use Installation before use - placing your dryer
Do not put any heavy or hot articles on
top of your dryer to avoid damage to the
Do not try to dry a raincoat, fl uffy clothes,
anything containing rubber or elasticity
materials inside the dryer.
To avoid any injury, only open the door of
the dryer when it has fi nish its cycle.
This section is left blank intentionally
This product belongs to type I electronic products. Please take note of safety issue as
1.Ensure that you use power which is buried in the earth and will not touch any social
equipment such as gas pipe or water pipe etc. Ensure that the lines are not connected.
2.Please use a power socket which meets the National Standard and will endure 10A current.
Dryer should be placed in a ventilated area with no
cm distance from the wall. If it is
in a room such as bathroom, it is recommended
there are no obstacles 1.5m in front of the dryer.
Step 2. Horizontal adjustment (Levelling of the clothes dryer)
Hang heavy objects on string on the front and one
side of the dryer (refer to the figure on the right). If
A=A and B=B, then the dryer is properly level.
Alternatively, use a spirit level.
(refer to fi gure on the right.)
NOTE:
If the dryer is not installed horizontally, the dryer
will be unbalanced whilst in motion and may stop
working.
otice when installing the unit:
Do not install the unit in the open air or where it may
come into contact with water.
. Do not place the back of the dryer near a curtain.
Do not place the dryer near gas or fl ammable area.
Do not place the dryer near gas or fl ammable area.
To Next Page
Loading...