A. PREPARATION BEFORE LOADING YOUR CLOTHES
hes into the dryer please
Installation before use - loading clothes
Clothes have to be washed and excess water removed before loading the
It is recommended to load the same type / colour when drying clothes.
Seperate lighter clothing from heavier clothing to ensure even circulation
inside the dryer. It is best to dry the clothes inside out.
Make sure any clothes with any decoration / buttons is safe for drying at
high temperature and will not damage the inner tub of the dryer.
It is better to turn pockets inside out for drying.
Before loading the dryer, check that the clothes are cleaned. Any residue
left on the clothing will not dissapear after drying and may damage the
Never put any sharp or heavy objects inside the inner tub of the dryer.
Please make sure that the power socket is well connected and will not
touch any conduit of water supply or gas supply.
Make sure that the fi lter is clean and in the correct position.
For drying fi ll the inner
tub to 1/3 - 1/2 capacity as space is need to
For drying fi ll the inner tub to 1/3 - 1/2 capacity as space is need to For drying fi ll the inner
circulate the clothes and dry evenly.
When drying bigger items such as bedsheets, it is better to mix with small
When drying out delicate clothing, it is best to mix with towels as not to
Do not over dry clothing as this may shrink some material.
Reference for drying clothing by weight
Installation before use - Control panel
3. Program (extra dry / middle dry / light dry / 1 hour)
4. Heat ( full / half / airing )
Note: Push program and heat control on the same time to operate LOCK
To Next Page
Loading...