LUMINELL RLX CxZ1.21 - SAFETY; General Safety Regulations

Luminell Norway AS Doc. Nr.: D0011 RLX CxZ1.21 User Manual v1.5
Page 2 of 9
1 GENERAL
The RLX CxZ1.21 is a compact and solid LED floodlight created to last in very harsh and corrosive
environments. It is designed to be used both in gas and dust environments, zones 1, 2, 21 and 22.
Read this user guide to get the most out of your RLX CxZ1.21 LED floodlight and help it to maximize its
potential for your application.
2 SAFETY
Inappropriate or unauthorized use or failure to comply with the information contained in these
instructions, voids any warranty and may invalidate the certificate. Modifications or changes to the
equipment are not allowed.
The following must be observed:
• national safety regulations
• national workplace health and safety regulations
• national installation and set-up regulations
• generally accepted engineering standards
• the safety information contained in these operating instructions
• the data and rated operating conditions
• disposal of waste, parts or floodlight in accordance with national regulations
• the ATEX or IECEx certificate
• the equipment is suitable for harmful or corrosive chemicals that may be
present
For the installation and operation of explosion-protected equipment, the
recognized rules of technology in accordance with EN60079-14 “Configuring and
selection”, and EN60079-17 “Test and maintenance”, and the accompanying
installation and operating instructions must be observed. Luminell reserves the
right to make technical changes to the product without notice.
3 TYPE OVERVIEW
RLX Cx Type and
Power consumption
Temperature Class
and rating
Input Voltage
Light Beam Alternatives
160 W
T3 -55°C ≤ Ta ≤ 55°C
T4 -55°C ≤ Ta ≤ 40°C
VAC:
100 - 277 VAC 50-60 Hz
VDC:
100-300 VDC
- Spot 15
- Medium 40
- Medium 60
- Medium 60 x 40
- Wide 80x60
- Oval 45 x 15
120 W
T4 -55°C ≤ Ta ≤ 55°C
80 W
T4 -55°C ≤ Ta ≤ 55°C
T5 -55°C ≤ Ta ≤ 50°C
40 W
T6 -55°C ≤ Ta ≤ 55°C
Do not open when
energized.
Crush hazard!
Be aware of moving parts
when lifting and mounting
the floodlight. Shall only
be installed by a qualified
electrician.