2. POWER UP THE DEVICE
Depending on the model there are different ways to power your device:
LumiNode1: Power-up the device with a USB cable (U) or with PoE (N). The
device will automatically switch on. To shut it down after use, just un-plug
the USB cable or the network cable again.
Luminode2: Power-up the device with a network cable with PoE (N). The
device will automatically switch on. To shut it down after use, just un-plug
the network cable again.
LumiNode4 and 12: Power-up the device with a power cable fitted with a
Neutrik PowerCON TRUE1 connector (M) (please contact your local dealer if
you don’t have a suitable power cable at hand). The device will automatically
switch on. To shut it down after use, just un-plug the power cable again.
Alternatively, the LumiNode series are 802.3af compliant (PoE), so that each LumiNode
will act as a PD (Powered Device), and can be powered by any compliant PSE (Power
Sourcing Equipment) such as Ethernet switch, midspan and PoE injector.
For LumiNode 4 and 12, if both 230V and PoE are used the 230V supply will be
prioritized but the PoE will seamlessly take over the running if the 230V fails.
The LumiNode12 offers the option to daisy chain up to 30 devices via the PowerCON
TRUE1 outlet on the rear of the unit.
To Next Page
Loading...
Need help?
General
