LUTEC 6222-D2D - Care and Maintenance; Troubleshooting

PROBLEM POSSIBLE CAUSE CORRECTIVE ACTION
The light will not go on.
1. No power to light.
2. There may be a poor
connection between the light
and supply wires inside the
junction box.
1. Check that the circuit is on,
wall switch is on, and there
is power to light fixture.
2. Check supply wire connections.
3. The photocell detects light or
sunlight nearby.
3. Avoid light directed at the
photocell at night. Cover
photocell with your hand.
The light comes on during
the day.
The light flashes.
1. The fixture may be installed
in a relatively dark location.
2. There is dust on the
photocell.
1. Something is reflecting the
light.
1. Relocate the fixture.
2. Periodically clean the surface
of the photocell with a mild,
non-abrasive cleaner.
1. Relocate the fixture away from
reflective surfaces.
TROUBLESHOOTING
• Clean surfaces with a mild, non-abrasive cleaner.
CARE AND MAINTENANCE
OPERATING INSTRUCTIONS
The photocell in the fixture is designed to detect light and
prevent the fixture from turning on when it senses daylight.
At dusk, the light will turn on throughout the night until dawn.
At dawn, the light will turn off throughout the day until dusk.
Photocell
Note: To check if the fixture is operating properly, cover the
photocell with your fingers so no daylight can reach the
photocell. The light should turn on and turn off when you
remove your fingers.If the fixture is installed in a shaded or
covered area where there is little direct sunlight, the light may
come on during the day.
6