6
Restoring Factory Default Settings
Restoring the Dynamic Keypad to factory settings will remove it from
the system and will clear its programming. Here’s how to reset it:
1. Triple tap and hold any of the hard buttons on the device.
Do not release after the third tap.
2. Keep the button pressed on the third tap until the LED starts to
rapid-flash (approximately 3 seconds).
3. Release the button and immediately (with ½ second) triple tap it
again. All LEDs will rapid-flash again.
After you return the Dynamic Keypad to factory settings you’ll need
to reactivate and transfer in the HomeWorks QS system.
Lights Shades
A/VTemperature
Energy Favorites
Kitchen
Areas
To Next Page
Loading...
Need help?
General
