Lutron Electronics MS-7003 User Manual

3)It is recommended that the test pins are inserted to a
minimum depth of 2 mm into the material under test.
If a depth of 2 mm can not be obtained, then insert the
test pins to their maximum achievable depth.
Fig. 2
4)Display will show the moisture contents in " %
moisture content " directly.
Consideration :
If the sample under test has a high moisture
content it may take a few minutes to obtain a
stable reading.
5

Lutron Electronics MS-7003 Specifications

General

Brand	Lutron Electronics
Model	MS-7003
Category	Measuring Instruments
Language	English