Lutron Electronics QSE-CI-NWK-E - User Manual

R
S P E C I F I C AT I O N S U B M I T TA L Page
Job Name:
Job Number:
Model Numbers:
QS System QSE-CI-NWK-E Control Interface
369373b 1 06.21.12
QSE-CI-NWK-E Control Interface
The QSE-CI-NWK-E is a versatile integration access
point for Lutron’s QS-based systems. Through either
RS232 or TCP/IP over Ethernet, third-party devices
can control and/or monitor a QS system.
Key Features
•Easilyintegratewithtouchscreens,PCs,A/Vsystems,
or other digital systems and devices.
•ControlandmonitorGRAFIKEye
® QS, Sivoia® QS,
Energi Savr Node
TM,andotherproductsonthewired
QS link.
•Monitorlightingscenes,levels,andshadepositions
•Uptoten(10)QSE-CI-NWK-Econtrolinterfacesare
allowedperQSlink.
•TheQSE-CI-NWK-EisQuantum
® compatible. Refer to
the Quantum
® System Specification Sheet for
compatibility details.
Compatible Components
ThefollowingdevicesarecompatiblewiththeQSlink.
Formoreinformationoneach,referto
www.lutron.com/qs.
•GRAFIKEye
® QS control units.
•seeTouch
®QSwallstations.
•Sivoia
® QS shades.
•QSInterfaces(contactclosure,Ethernet/RS232).
•Quantum
® system.
•EnergiSavrNode
TM units.
•QSSensorModule.
•QSKeyswitch.
Requirements
•QSLinkPowerSupply,suchasa:
 -GRAFIKEye
® QS.
 -QSLinkpowersupply,suchastheQSPS-P1-1-50.
- Energi Savr Node
TM QS.
•QSCommunicationLink(IECPELV/NEC
®Class2)
(seeQSLinkWireSizestable).
Protocol
•ProtocoldocumentP/N040-249includedona
CD accompanying the packaged QSE-CI-NWK-E.
•Alsoavailablefordownloadatwww.lutron.com/qs.

Lutron Electronics QSE-CI-NWK-E Specifications

General

Brand	Lutron Electronics
Model	QSE-CI-NWK-E
Category	Recording Equipment
Language	English

Summary

QSE-CI-NWK-E Control Interface Overview

Key Features of QSE-CI-NWK-E

Lists the primary benefits and integration capabilities of the QS-CI-NWK-E.

System Requirements

Specifications and Connections

RS232 Connection Configuration

Details the RS232 connection, including DIP switch settings for baud rate.

Ethernet Connection Setup

Describes the Ethernet connection, cable requirements, and default IP address.

Wiring and Connectivity

RS232 Wiring Details

Specifies the RS232 connection requirements, cable length, and pinout.

Ethernet Wiring Requirements

QS Link Wiring Methods and Specifications

QS Link Wiring Standards

Details IEC PELV/NEC Class 2 wiring, terminal capacity, and total link length.

QS Link Wire Gauge and Cable Part Numbers