Lutron Electronics Sivoia QS roller 100 - Mount Sub-brackets; Position Sub-brackets; Insert Sub-brackets

Pocket width
System width
Fabric width
Ceiling
Sub-Bracket detail
ceiling
glass
0.75 in.
(19mm)
Finished Position
Fabric
Alignment
Holes
0.75 in.
(19mm)
4
Mount sub-brackets
4.1
Use fabric alignment holes to
position the sub-bracket right
to left. The fabric alignment
holes will line up with the out-
side edge of the shade tube.
Note: Fabric edge may not
line up with the edge of tube.
4.2
Once their position has
been established, insert
sub-brackets by hooking
their lower edges behind
notch in pocket surface.
If endcaps are being used,
they must be installed
prior to sub-brackets.
ceiling
Pocket width
Fabric width
System width
0.75 in
(19 mm)
0.75 in
(19 mm)
Fabric
Alignment
Holes
Sub-Bracket detail
ceiling
glass
Finished position
Page 7
Sivoia® QS roller 100TM Pocket Mount Installation instructions