LUX SMART TEMP TX9100U - TX9100 U_ENG_Manual_Page 24

for heat pump configurations). An Offset value from 1 to 9 degrees will
determine the number of degrees from the set point that will be required for
the second heating stage to turn on. This setting can be used to conserve
energy in situations where the second heating stage is more costly to
operate when compared to the first stage.
70˚F Set
Temperature
71
DEGREES (F)
** = Only applies if a second
heat stage is present
70
69
68
67
66
65
Swing
Setting=
#2 (+/- 0.5˚F)
Cut-In / Cut-Out
(1
st
Stage)
(2
nd
Stage) **
Cut-In / Cut-Out
Offset **
Setting=
4˚F degrees
24