Need help?Do you have a question about the Luxman L-510 and is the answer not in the manual?
General| Type | Integrated Amplifier |
|---|---|
| Frequency Response | 10Hz to 100kHz |
| Input Sensitivity (MM) | 2.5mV |
| Input Sensitivity (Line) | 150mV |
| Signal-to-Noise Ratio (MC) | 75dB |
| Signal-to-Noise Ratio (MM) | 90dB |
| Speaker load impedance | 4Ω to 16Ω |
| Power Output | 100 watts per channel into 8Ω (stereo) |
Diagrams showing the physical locations of VR401 and VR402 for main amplifier adjustments.
Diagrams illustrating the physical locations of VR101a/b, VR102, and VR103 for equalizer section adjustments.
Detailed procedure for aligning DC offset and idling current on the main amplifier section.
Procedure for aligning the DC offset in the equalizer section of the amplifier.
Instructions for operating the function switch, including diagrams.
Instructions for operating the cartridge switch, including diagrams.
To Next Page
