Need help?Do you have a question about the Luxman L-590AX and is the answer not in the manual?
General| Type | Integrated Amplifier |
|---|---|
| Output Power | 30W + 30W (8Ω), 60W + 60W (4Ω) |
| Input Impedance | 47kΩ (LINE) |
| Frequency Response | 20Hz-20kHz (+0, -0.5dB) |
| Signal-to-Noise Ratio | 105dB (LINE) |
| Dimensions | 440 x 193 x 463 mm |
Discusses optimal placement for heat dissipation and keeping ventilation holes clear for the amplifier.
Advises turning off power during connections and warns against short-circuiting speaker terminals.
Explains sound delay on power-on, protection circuit, battery caution, and cleaning methods.
Highlights LECUA-WM attenuator and ODNF distortion-negative feedback for sound quality.
Details parallel push-pull output, high-inertia power supply, and beeline construction.
Notes use of selector switch IC, Schottky diodes, OFC wires, and round pattern boards.
Describes phono amplifier, separate function, and chassis structure for enhanced performance.
Covers speaker terminals, ventilation, chassis, meters, and remote control.
Explains the operation switch, indicator, input selector, and input indicator.
Details the volume control, headphone jack, and display indicators.
Describes the line straight switch, balance control, and treble tone control.
Covers bass tone control, speaker selector, recording switch, and cartridge selector.
Explains monitor, power meters, subsonic, and monaural indicators.
Details standby, remote, loudness, line straight, and separate indicators.
Describes signal ground, phono, LINE inputs, and recorder I/O terminals.
Covers pre-out, main-in, balanced inputs, phase inverters, AC inlet, and speaker terminals.
Guides on connecting power, audio sources like CD players, and speakers.
Details connecting record players, recorders, and using separate pre-amp/main-amp sections.
Covers pre-operation checks, playback steps, and using line straight/balance controls.
Explains tone control adjustments and how to record audio sources.
Details timer-controlled operations, memory storage, and reset procedures.
Covers power, input selection, mute, and meter control via remote.
Explains monaural, separate, subsonic, loudness, and volume controls with battery info.
Details power output, distortion, frequency response, and S/N ratio.
Lists pre-amp/main-amp sensitivities, tone control range, and loudness.
Covers damping factor, accessories, power supply, dimensions, and weight.
Solutions for issues like no power, no sound, or sound on one side.
Troubleshooting for humming noise and non-responsive controls.
Solutions for meter lights not turning on and remote control issues.
To Next Page
